Cycle 0612 error

Gustavo · Post by **Gustavo** » Tue Dec 12, 2006 9:04 pm

"Hi, just took a test with 0612 and it gave 2 error lines with EDDF airport as destination, and it was not possible choose a runway to land cause runways were missed. Anyone got this problem too?..just to know if it's an error in the cycle of it's mine the problem. regards."

Christian Alton · Post by **Christian Alton** » Tue Dec 12, 2006 9:51 pm

Yes I have this on a bunch of airports it is in the SID and STARS file that are not done correctly

Brogs · Post by **Brogs** » Wed Dec 13, 2006 6:45 am

"The fault has to be in the Cycle.it didn,t recognise RWY 22 at Gander International and it had no Rwys at all for Heathrow, one of the Busiest Hubs in the World ! Mike

"

rossspargo · Post by **rossspargo** » Wed Dec 13, 2006 7:09 am

"I have the same errors for Cycle 0609. I dont know if it is because it is a demo version or not, but it seems to be working OK now. All i did, was went onto SID/STAR information on the navdata website, where I downloaded the all-in-ine package for the PMDG. Works OK now

However, I am going to upgrade when Navdata come together with the Cycle, SID and STAR information in one whole download, like it already has for a couple of add-ons! Ross S"

Gustavo · Post by **Gustavo** » Wed Dec 13, 2006 8:15 am

"Hi all, I will try your solution Ross, just downloaded the all-in-one file for PMDG. Will check later if all fixed. Thanks for the idea. regards."

rossspargo · Post by **rossspargo** » Wed Dec 13, 2006 3:38 pm

"Hey Gustavo, No problem! Like I said, works for me (touch wood)

Ross S"

Covert53 · Post by **Covert53** » Wed Dec 13, 2006 8:39 pm

Don't know if this solution works but I had the same problem with KATL. When i initially activated the route I got an error regarding RWY 10 there. I ignored it and when I was trying to prep for my arrival no runways at all for KATL appeared in the FMC. My AFCAD file didn't contain the new 10/28 runway so there was some disagreement. I went into the AIRAC file and deleted all ines for 10 and 28 and it now works. Now I can't be sure that my action was the appropriate remedy. I also don't know if the PMDG code checks to see if AIRAC file jives with the AFCAD. But it worked for me. For what its worth...