Page 1 of 1

"Can,t open A1 Package"

Posted: Wed Aug 29, 2007 8:39 am
by Brogs
"I,ve tried to d/load or Install from the Site with no luck, I keep getting the "Can,t open, doesn,t appear to be a Valid Archive" message, plus it d/loads at about 4kb per sec. Mike :cry:"

Posted: Wed Aug 29, 2007 12:22 pm
by nwadc10
I don't know what could be causing that. I've experience symptoms like that before and was fixed by either clicking on save (not open) and if that doesn't work right click and select Save Target As... Otherwise I'll look more into it but currently it's working on my system. Justin

Posted: Wed Aug 29, 2007 12:28 pm
by Avwriter
Do you have a firewall that might be interfering? Try disabling it.

Posted: Wed Aug 29, 2007 5:48 pm
by rossspargo
"Justin, I think there might be something a bit more difficult to figure out then what you may have originally thought! I tried to download the Atlas repaint for the 747-200, but that too had no files to extract :shock: :x Hope its not too difficult to repair :("

Posted: Wed Aug 29, 2007 6:06 pm
by nwadc10
I am reproducing the error with the AI package now but not with the atlas repaint which downloaded and opened fine. For the AI package the only folder i'm getting in full is the atlas 742 AI model. I'm looking into to it to find a solution. Justin

Posted: Wed Aug 29, 2007 7:06 pm
by nwadc10
"The download is showing weird behavior. Every other time I download the file it works, the other times it doesn't. Try downloading it again, if the full 2.8 MB doesn't download try again and replace the bad downloaded file. Let me know if this works. Justin"

Posted: Fri Aug 31, 2007 11:22 am
by Brogs
"Ain,t working Justin, I,ve tried four times, get a different value each time , the last one was 240 kb, Mike :?"