Getting Pirep system connected to P3D

Here is where the coffee machine and Coke machine are kept. Please clean up after yourself and do not remove the magazines from this area. A good place to exchange thoughts with Operations personel and other pilots.

Moderators: Staff, HR, Flight Ops

Post Reply
1888
www.meble-kuchenne.warszawa.pl

Getting Pirep system connected to P3D

Post by 1888 »

I have recently updated to Prepar3d v3. What do I need to do in order to get the Globe Cargo Pirep system to connect to P3D?

Thanks
Top
User avatar
nwadc10
Site Admin
Posts: 3948
Joined: Wed Jun 09, 2004 10:17 pm
Location: Ramsey, MN, USA

Re: Getting Pirep system connected to P3D

Post by nwadc10 »

Install FSUIPC into P3D, then point the FSX folder locations in GCP User Setup to the appropriate P3D locations for those same folders.

Should be good to go from there.
Justin Erickson, Captain #1040
Chief Executive Officer
Globe Cargo PIREP (GCP) Developer
ceo-at-globecargova.org
Vatsim ID: 871725

Image
Top
Post Reply

Return to “Pilots Lounge”